Cisco 350-401 dumps - 100% Pass Guarantee!

An engineer measures the Wi-Fi coverage at a customer site. The RSSI values are recorded as follows:

Location A: -72 dBm Location B: -75 dBm Location C: -65 dBm Location D: -80 dBm

Which two statemets does the engineer use to explain these values to the customer? (Choose two)

A. The signl strength at location B is 10 dB better than location C

B. Location D has the strongest RF signal strength.

C. The signal strength at location C is too weak to support web surfing.

D. The RF signal strength at location B is 50% weaker than location A

E. The RF signal strength at location C is 10 times stronger than location B

Refer to the exhibit.

MTU has been configured on the underlying physical topology, and no MTU command has been configured on the tunnel interfaces. What happens when a 1500-byte IPv4 packet traverses the GRE tunnel from host X to host Y, assuming the DF bit is cleared?

A. The packet arrives on router C without fragmentation.

B. The packet is discarded on router A

C. The packet is discarded on router B

D. The packet arrives on router C fragmented.

Which features does Cisco EDR use to provide threat detection and response protection?

A. containment, threat intelligence, and machine learning

B. firewalling and intrusion prevention

C. container-based agents

D. cloud analysis and endpoint firewall controls

What happens when a FlexConnect AP changes to standalone mode?

A. All controller-dependent activities stop working except the DFS.

B. All client roaming continues to work

C. Only clients on central switching WLANs stay connected.

D. All clients on an WLANs are disconnected

Refer to the exhibit.

A network engineer configures NAT on R1 and enters the show command to verify the configuration. What does the output confirm?

A. The first pocket triggered NAT to add on entry to NAT table

B. R1 is configured with NAT overload parameters

C. A Telnet from 160.1.1 1 to 10.1.1.10 has been initiated.

D. R1 to configured with PAT overload parameters