Cisco 350-601 dumps - 100% Pass Guarantee!

A network engineer configures a converged network adapter (CNA) and must associate a virtual fiber Channel 7 interface to VSAN 7. The CAN connected to the interface Eth1/7, and VLAN 700 is mapped to the VSNA.

Which configuration must be applied to create the virtual Fiber Channel interface and associate it with the Ethernet physical interface?

A. Option A

B. Option B

C. Option C

D. Option D

An engineer must recover the Cisco UCS system The full backup is available on a backup SCP server Which set of actions recovers the configuration of the Cisco UCS Manager?

A. Create an import-config task. Set the action to Replace.

B. Copy the backup file to a USB drive. Copy the running-config.

C. Factory reset the fabric interconnect. Select the Restore feature.

D. Create a scheduled restore job. Reboot the UCS Manager.

An engineer is implementing traffic monitoring for a server vNIC that is configured with fabric failover enabled. The requirement is for the traffic to be sent to an analyzer, even during a failure of one of the fabric interconnects. The analyzer is connected to unconfigured Ethernet ports on both fabric interconnects.

Which configuration accomplishes this task?

A. Create two traffic monitoring sessions with different names, one per fabric. Connect an analyzer on each FI as the destination for the monitoring session local to the FI.

B. Create two traffic monitoring sessions with the same name, one per fabric. Connect the analyzer connected to FI-A as the destination for both monitoring sessions.

C. Create two traffic monitoring sessions with different names, one per fabric. Connect the analyzer connected to FI-B as the destination for both monitoring sessions.

D. Create two traffic monitoring sessions with the same name, one per fabric. Connect an analyzer on each FI as the destination for the monitoring session local to that FI.

Which two components are used by the Cisco Nexus switches telemetry process? (Choose two)

A. data encoding

B. data manipulation

C. telemetry agent

D. telemetry compression

E. data collection

A network engineer must configure a Fibre Channel interface on the Cisco MDS 9000 Series Switch The configuration must meet these requirements

1.

The interface must be disabled when the bit errors threshold Is exceeded

2.

Buffer-to-buffer credits must be set to the maximum value

3.

The interface must have full bandwidth allocated for its port group

Which command set configures a Fibre Channel interface that meets these requirements?

A. interface fc1/1 switchport bit-errors switchport fcrxbbcredit 220 mode Fx switchport rate-mode dedicated

B. interface fc1/1 switchport ignore bit-errors switchport fcrxbbcredit 255 mode Fx no switchport rate-mode

C. interface fc1/1 no switchport ignore bit-errors switchport fcrxbbcredit 255 mode Fx switchport rate-mode dedicated

D. interface fc1/1 no switchport bit-errors switchport fcrxbbcredit 220 mode Fx no switchport rate-mode