Cisco 600-511 dumps - 100% Pass Guarantee!

Which three main problems was a host overlay system designed to address? (Choose three.)

A. workload mobility

B. simplified and automated workload provisioning

C. multitenancy at scale

D. integrate physical and virtual networking

E. increase visibility to traffic flows

F. better root cause analysis capabilities

G. consolidate IT infrastructure teams

Which two methods to scale bandwidth and capacity enable capacity planning and scaling in the ACI fabric? (Choose two.)

A. Scale-out spine nodes for bandwidth.

B. Increase Cisco APIC uplinks to fabric for bandwidth.

C. Interconnect spine nodes.

D. Scale-out leaf nodes for capacity.

E. Leverage QoS on the Cisco APIC uplinks.

Which three options are the primary benefits of a leaf-spine architecture? (Choose three.)

A. linear scalability

B. robust multipathing

C. use of Rapid PVST

D. deterministic latency

E. increased scalability of the proxy database

F. 1.5:1 oversubscribed ports

G. best suited for integration into an access/aggregation/core topology

Which statement about the infrastructure requirements for an ACI fabric is true?

A. Hypervisors that connect to the ACI fabric must support the Cisco Discovery Protocol so that ACI can discover the presence of virtualized hosts and deploy policies to the ports on which a virtualized host is present.

B. The Cisco Nexus 9336PQ form factor is well suited for large enterprise ACI deployments because it provides 288 40 Gigabit Ethernet ports at the spine.

C. Leaf and spine switches can connect at 40 Gbps with multimode fiber by using the Cisco 40 Gbps short-reach bidirectional QSFP optics modules, which do not require new cabling.

D. The Cisco ACI fabric uses an overlay, based on MPLS VPN, to virtualize the physical infrastructure. This overlay maps the tenant endpoint addresses to the location of the endpoint using the tunnel endpoint.

Which two options are two intended uses of Layer 3-External in the ACI fabric? (Choose two.)

A. to provide connectivity to external networks

B. to advertise a default gateway into the ACI fabric

C. to define the default gateway for the devices connected to the ACI fabric

D. to advertise IP and MAC information outside of the ACI fabric

E. to apply policy to endpoints not contained in an EPG