Cisco 300-630 dumps - 100% Pass Guarantee!

Which two actions should be taken to ensure a scalable solution when multiple EPGs in a VRF require unrestricted communication? (Choose two.)

A. Configure a taboo contract between the EPGs that require unrestricted communication between each other.

B. Enable Preferred Group Member under the EPG Collection for VRF section.

C. Set the VRF policy control enforcement preference to Unenforced.

D. Set the EPGs that require unrestricted communication between each other as preferred group members.

E. Set the EPGs that require policy enforcement between each other as preferred group members.

Refer to the exhibit. Which configuration must be implemented to allow intra-VRF transit routing between the two external routers?

A. Deploy both areas under the same L3Out policy

B. Change one of the areas to area 0

C. Configure OSPF virtual links

D. Modify L3Out 1 to use the same OSPF area as L3Out 2

An engineer configures a Cisco ACI Multi-Pod for disaster recovery. Which action should be taken for the new nodes to be discoverable by the existing Cisco APICs?

A. Enable subinterfaces with dot1q tagging on all links between the IPN routers.

B. Configure IGMPv3 on the interfaces of IPN routers that face the Cisco ACI spine.

C. Enable DHCP relay on all links that are connected to Cisco ACI spines on IPN devices.

D. Configure BGP as the underlay protocol in IPN.

A customer is deploying a new application across two ACI pods that is sensitive to latency and jitter. The application sets the DSCP values of packets to AF31 and CS6, respectively. Which configuration changes must be made on the APIC to support the new application and prevent packets from being delayed or dropped between pods?

A. disable DSCP translation policy

B. align the ACI QoS levels and IPN QoS policies

C. disable DSCP mapping on the IPN devices

D. align the custom QoS policy on the EPG site in the customer tenant

An engineer must implement a full mesh Cisco ACI Multi-Site architecture. Which action must be taken on each spine to accomplish this goal?

A. Configure BGP-EVPN Router-ID

B. Configure Multi-Pod Data-Plane TEP

C. Configure Overlay Unicast TEP

D. Configure Overlay Multicast TEP