HP HPE2-Z40 dumps - 100% Pass Guarantee!

A network administrator connects several newAruba Instant APs (at factory defaults) to a switch. After

waiting several minutes for the cluster to form, the administrator is ready to provision the cluster. The

VLAN on the ports connected to the APs has no DHCP services.

How can the administrator contact the Instant UI and provision the APs with static IP addresses?

A. Connect to the Instant SSID and open a Web browser.

B. Access the default IP address, 192.168.1.1, from a device connected in the AP VLAN .

C. Access the cluster using Aruba Activate.

D. Access https://vc.arubanetworks.com from a device connected in the AP VLAN.

A network administrator configures LLDP-MAD on an Aruba Virtual Switching Framework (VSF) fabric The administrator needs to enter an SNMP community string after v2c in this command: Swich(config)# vsf Ildp-mad ipv4 10.1.0.2 v2c

Which SNMP community string should the administrator enter?

A. one configured for the VSF fabric on AirWave.

B. one configured on the device at 10.1.0.2.

C. one configured on the standby member in the fabric.

D. one configured on the VSF fabric as a whole.

An ArubaOS switch has no passwords or user accounts configured on it. A network administrator then enters these commands: Switch(config)# password manager user-name admin1 plaintext mysecret1 Switch(config)# password manager user-name admin2 plaintext mysecret2 Switch(config)# aaa authentication local-user admin3 group Level-15 Password plaintext New password for admin3: hpe Please retype new password for admin3: hpe Which users can access the switch CU and use enable and global configuration commands?

A. Admin1 and admin2

B. admin2 and admin3

C. admin1 and admin3

D. admin1 admin2, and admin3

Refer to the exhibit.

An Aruba Instant cluster is added in Aruba AirWave. A network administrator needs to change the cluster management level to Manage Read/Write. The exhibit shows the current status for the cluster. What should the administrator do before changing the management level?

A. Determine why AirWave cannot contact the cluster and resolve any connectivity issues in the network.

B. Check the cluster SNMP credentials and resolve the mismatch between the cluster credentials and AirWave credentials.

C. Investigate why the cluster configuration does not match the group configuration template and resolve any issues.

D. Verify that the cluster is configured with the same shared key that is configured in the global AirWave settings.

What is the purpose of the organization string that is set in the System > Admin settings of an Aruba Instant UI?

A. It configures the SNMP credentials that Aruba AirWave uses to discover the cluster.

B. It directs the cluster to the proper Aruba Activate account for Zero Touch Provisioning (ZTP).

C. It prevents unauthorized APs, which do not have the correct organization string, from joining the cluster

D. It defines the group and folder to which the Instant cluster should be assigned in Aruba AirWave.