EMC DES-6321 dumps - 100% Pass Guarantee!

When adding an S Series node to a Gen 2 VxRail 240F cluster the build fails.

What could be a possible cause of this situation?

A. IP Pool has no more free addresses

B. Hybrid and Flash nodes cannot be mixed in the same cluster

C. Quanta and Dell hardware cannot be mixed in the same cluster

D. Loudmouth process needs to be restarted

During a node add procedure the new node cannot be discovered. A ping to the IPv6 address is responding.

What could be the cause of this issue?

A. Only one network interface is up on the new node

B. vSAN VLAN is not configured correctly

C. Management VLAN ID is not set on the vmk0 interface

D. Loudmouth process is not running

The vCenter managing a VxRail cluster must be able to support both Enhanced Linked Mode and vSAN Encryption.

What is the correct configuration to satisfy this requirement?

A. External vCenter External PSC

B. Embedded vCenter Embedded PSC

C. External vCenter Embedded PSC

D. Embedded vCenter External PSC

What is the maximum number of nodes in a VxRail cluster when using 1 GbE links?

A. 4

B. 8

C. 16

D. 32

A VxRail Stretched Cluster will be configured with four All-Flash nodes at each site based on the following requirements:

PFTT = 1 SFTT = 1 FTM = Erasure Coding

Based on the required usable capacity, what should be the planned capacity of the design?

A. Single Site Capacity = 150% Total Cluster Capacity = 300%

B. Single Site Capacity = 133% Total Cluster Capacity = 266%

C. Single Site Capacity = 100% Total Cluster Capacity = 200%

D. Single Site Capacity = 200% Total Cluster Capacity = 400%