Fortinet NSE5_FMG-6.0 dumps - 100% Pass Guarantee!

In addition to the default ADOMs, an administrator has created a new ADOM named Training for FortiGate devices. The administrator sent a device registration to FortiManager from a remote FortiGate. Which one of the following statements is true?

A. The FortiGate will be added automatically to the default ADOM named FortiGate.

B. The FortiGate will be automatically added to the Training ADOM.

C. By default, the unregistered FortiGate will appear in the root ADOM.

D. The FortiManager administrator must add the unregistered device manually to the unregistered device manually to the Training ADOM using the Add Device wizard

When installation is performed from the FortiManager, what is the recovery logic used between FortiManager and FortiGate for an FGFM tunnel?

A. After 15 minutes, FortiGate will unset all CLI commands that were part of the installation that caused the tunnel to go down.

B. FortiManager will revert and install a previous configuration revision on the managed FortiGate.

C. FortiGate will reject the CLI commands that will cause the tunnel to go down.

D. FortiManager will not push the CLI commands as a part of the installation that will cause the tunnel to go down.

View the following exhibit.

Which of the following statements are true if FortiManager and FortiGate are behind the NAT devices? (Choose two.)

A. FortiGate is discovered by FortiManager through the FortiGate NATed IP address.

B. FortiGate can announce itself to FortiManager only if the FortiManager IP address is configured on FortiGate under central management.

C. During discovery, the FortiManager NATed IP address is not set by default on FortiGate.

D. If the FGFM tunnel is torn down, FortiManager will try to re-establish the FGFM tunnel.

What is the purpose of the Policy Check feature on FortiManager?

A. To find and provide recommendation to combine multiple separate policy packages into one common policy package

B. To find and merge duplicate policies in the policy package

C. To find and provide recommendation for optimizing policies in a policy package

D. To find and delete disabled firewall policies in the policy package

An administrator is unable to log in to FortiManager. Which one of the following troubleshooting step should you take to resolve the issue?

A. Make sure FortiManager Access is enabled in the administrator profile

B. Make sure Offline Mode is disabled

C. Make sure the administrator IP address is part of the trusted hosts.

D. Make sure ADOMs are enabled and the administrator has access to the Global ADOM