NS0-162 Online Practice Questions and Answers

All SMB users are reporting that their network share performance Is slow on a new NetApp FAS500f HA pair. You determine that the users have converged network adapters (CNAs) with flow control enabled and no option to disable. In this scenario, which two flow control settings are recommended on the NetApp ONTAP physical ports? (Choose two.)

A. Disable flow control end-to-end on data network ports.

B. Enable flow control end-to-end on cluster network ports.

C. Enable flow control end-to-end on data network ports.

D. Disable flow control end-to-end on cluster network ports.

A customer has a 2-node AFF A220 cluster and needs to enable the FC protocol. The onboard UTA2 ports are configured for 10Gbps Ethernet. In this scenario, what are two different methods to use FCP over the UTA2 ports? (Choose two.)

A. Swap the Ethernet transceivers in the UTA2 ports for 1Gbps transceivers, and configure the ports as target ports.

B. Connect onboard UTA2 ports to a Nexus switch and enable FCP.

C. Swap the Ethernet transceivers in the UTA2 ports for FC transceivers, and configure the ports as target ports.

D. Change the existing UTA2 ports from 10 Gbps speed to 8 Gb speed.

The source NAS volume of a SnapMirror relationship is unavailable due to networking issues at your organization's primary data center. You want to make the destination NAS volume writable so that clients are able to access their data. Which two steps do you need to take to solve the issue? (Choose two.)

A. Break the SnapMirror relationship using the snapairrcr break command from the destination cluster.

B. Delete the SnapMirror relationship from the destination cluster.

C. Use the volume mount command to mount the NAS volume In the NFS namespace.

D. Break the SnapMirror relationship using the snapmirror break command from the source cluster.

You are asked to deploy a 2-node ONTAP Select cluster. The physical hardware Is located In two different locations and you want the aggregates mirrored synchronously between the two data centers. You must ensure high availability and automated switchover.

In this scenario, which two steps would you take to fulfill this requirement? (Choose two.)

A. Ensure that the ONTAP Select Deploy VM resides at a third location other than the two data centers.

B. Install the SnapMirror Sync license on the cluster.

C. Use ONTAP Mediator service to make sure that you have a quorum for the two nodes.

D. Use ONTAP Select Deploy to Install the nodes on the physical hardware.

Exhibit.

You have an ONTAP 9.8 cluster. After network maintenance, the LIF that is shown in the exhibit is not always on a correct port and is unreachable by users until the LIFs are moved to port eOc or eOd on either storage node. In this scenario, which action should you take to ensure that the LIF only fails over to the correct ports?

A. Create a DNS load balancing zone.

B. Split the broadcast domain.

C. Create an IPspace.

D. Change the LIF's failover policy to sfo-partner-only

You have finished deploying a NetApp AFF A400 cluster.

Before you place the array into production, which two tools should be used to validate the deployment? (Choose two.)

A. OnCommand Workflow Automation

B. Active IQ Unified Manager

C. Active IQ Config Advisor

D. Active IQ Web site

What establishes a quorum in a 4-node cluster?

A. epsilon

B. cluster peer

C. ONTAP Mediator

D. TieBreaker

After attempting to perform an ONTAP upgrade. It falls during the pre-check. In this scenario, what would cause this problem?

A. encrypted volumes

B. offline volume

C. Idle SnapMirrors

D. offline data LIF