HP HPE6-A45 dumps - 100% Pass Guarantee!

Refer to the exhibits. Exhibit 1

Exhibit 2

Switch-1 and Switch-2 are configured to provide VRRP in VLAN 2. The default gateway for VLAN 2 is set to the VRRP virtual IP. Client-1 in VLAN 2 cannot ping its default gateway.

Based on the exhibits, what can administrators determine?

A. The VRRP preempt delay time has not yet expired, and administrators should try to ping the gateway again in several minutes.

B. Switch-1 and Switch-2 have the same virtual router ID. The conflict interferes with connectivity.

C. Preempt mode is enabled on both Switch-1 and Switch-2, so the Master role continues to alternate between them, and the pings go astray.

D. This is the expected behavior, and Switch-1 should still be able to route traffic for Client-1.

The security policy for a company requires that switches use SNMPv3 and accept all read-only SNMPv2c messages. The network administrator enables SNMPv3.

Which additional action should the network administrator take to comply with this policy?

A. Disabled SNMPv3 inform timeouts.

B. Enable SNMPv3 only operation.

C. Enable SNMPv3 restricted mode.

D. Disable SNMPv1/v2c.

The security plan for AOS-Switches requires protection from incoming malware traffic: generated from a worm-or virus-infected host.

Which feature should be implemented to provide the required protection?

A. DHCP snooping

B. connection-rate filtering

C. port security

D. proxy ARP

Which situation requires an AOS-Switch interface to support MAC-based VLANs?

A. The interface has an extended MAC ACL applied to it in the outbound direction, and it uses VLAN ID as one of the criteria for rules.

B. The interface has an extended MAC ACL applied to it in the inbound direction, and it has multiple tagged VLAN assignments.

C. The interface is configured to support Local MAC Authentication (LMA), authenticates endpoints against a non-default MAC group, and limits the address count to 1.

D. The interface is configured to support 802.1X in user-based mode, connects to more than one endpoint at a time, and users are assigned to different dynamic VLANs.

Refer to the exhibits.

Exhibit 1

Exhibit 2

In the exhibits, VLAN 20 under a device name indicates that the device is configured with that VLAN. The exhibits also indicate whether VLAN 20 is statically configured on each link, either as an untagged or a tagged VLAN. If the link has no label, VLAN 20 is not statically configured on that link.

A network administrator needs to deploy AOS-Switches at the access layer. They enforce 802.1X on edge ports. In the exhibits, Switch-1 represents the access layer switches. The plan calls for users to be dynamically assigned to VLAN 20 or VLAN 30, based on identity. If the RADIUS server authorizes the user but does not assign a VLAN, the user should be assigned to VLAN 30. Switch-2 is the default router for the user VLANs.

Which exhibit shows the correct plan for VLAN 20 in the wired infrastructure?

A. A

B. B

C. C

D. D