Which switch mode is used to manage files and display switch information?
A. Interface
B. Network
C. Exec
D. Configuration
Which LSA type contains information about routes redistributed into OSPF?
A. 3
B. 10
C. 5
D. 8
Refer to the exhibit.
No static routing has been configured. For iBGP loopback-based peering, which statement is correct?
A. It is not necessary for the routing table on S1 to have an entry for the loopback network of S3.
B. S1 should have the Loopback network of S3 in its routing table for loopback-based peering.
C. For iBGP peering, physical interface addresses must be used.
D. A static route on S1 to 144.254.32.1/32 will eliminate the need for loopback-based peering with S3.
How are multiple hardware based ACLs filtered?
A. NTP
B. DHCP
C. NPU
D. IP
An administrator is implementing VLT in OS10. What type of port-channel must they configure for the VLTi?
A. Administrator needs to configure a LACP Port-Channel.
B. Trunking and one (1) native VLAN need to be defined on the port-channel.
C. None, a port-channel is created automatically during VLT discovery.
D. Administrator needs to configure a static Port-Channel.
A customer has disabled LLDP on the management interface of the switch. What is the proper command to re-enable it?
A. OS10(config)# lldp enable OS10(config)#lldp transmit OS10(config)#lldp receive
B. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp med enable OS10(conf-if-ma-1/1/1)#lldp timer 10
C. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp transmit OS10(conf-if-ma-1/1/1)#lldp receive
D. OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)#lldp tly-select OS10(conf-if-ma-1/1/1)#lldp dot1tlv
What type of network in a Data Center flattens the core and aggregation layers into a single tier?
A. Leaf
B. Leaf-spine
C. Spine
D. TRILL