GE0-807 Online Practice Questions and Answers

What is the default timeout defined in the SIP specification after which SIP Server will put a DN not responding to INVITE in Out of Service?

A. 2 Seconds

B. 4 Seconds

C. 8 Seconds

D. 16 Seconds

E. 32 Seconds

F. 64 Seconds

When the internal registrar is enabled and SIP Server is also configured to store registration information in the configuration database, where, in CME, can you find the contact option specifying current location?

A. corresponding DN

B. corresponding Agent Login

C. corresponding Voice over IP Service

D. corresponding SIP Server

E. It is not visible in CME

T-Lib messages can be mapped to all of the SIP messages listed below except which of the following?

A. INVITE

B. UPDATE

C. REFER

D. REGISTER

You have 3 separate remote sites using SIP technology without PBX. One location has one MOH and one MCU server, second location has a one MOH and one treatment server and third site has one MOH and one recording Media Server installed. The whole contact center has a rate of 30calls/sec. What is the minimal number of SIP servers to be installed?

A. 0

B. 1

C. 2

D. 3

Which of the following are valid configurations for Open standard SIP architecture? Choose 2 answers

A. l SIP Server, 1 Softswitch

B. 5 SIP Server, l Network SIP Server

C. 1SIP Server, 1 T-Server

D. 3 SIP Server, 5 T-Server, l Cisco call Manager

How is the Genesys SIP Server licensed?

A. per seat

B. per running instance

C. per any DN

D. per Agent

Which of the following are SIP methods that can be used to pass DTMF tones? (Choose 3 answers)

A. In-band method by encoding DTMF tone as regular RTP packets

B. In-band method by encoding DTMF tone as in specific RTP packets (RFC 2833)

C. Out-of-band method by encoding DTMF tone in SIP message (UPDATE method)

D. Out-of-band method by encoding DTMF tone in SIP message (MESSAGE method)

E. Out-of-band method by encoding DTMF tone in SIP message (INFO method)

When SIP Server is behind the Softswitch, a DN is considered out of service if it receives which of the following messages?

A. 408 Request Timeout

B. 404 Busy

C. 482 Gone

D. 486 Forbidden

When using the REFER method, where would you specify the party the call is being transferred to?

A. Refer header URI

B. To: header

C. contact: header

D. REFER To: header

E. Is not specified in the REFER messages

When comparing the network bandwidth and performance (jitter, packet loss, latency) between G.711 and

6.729 codes, which one of the statements is true?

A. G.729 and G.711 have the same bandwidth and network performance requirements

B. G.729 requires less bandwidth than G.711, but G.711 requires better network performance

C. G.729 requires less bandwidth than G.711, and there are no differences between G.711 and G.729 in there required network performance

D. G.729 requires less bandwidth than G.711, but G.729 requires better network performance

You have 3 separate remote sites using SIP technology without P8X. One location has one MOH and one MCU server, second location has a one MOH and one treatment server and third site has one MOH and one recording Media Server installed. The whole contact center has a rate of 30calls/sec. What is the minimal number of Network SIP servers needed for this installation?

B. 1

C. 2

D. 3

Which statements are correct? (Choose 2 answers)

A. A third-party Softswitch must be integrated with sip server using a CTI link.

B. If there are multiple outbound dialing rules configured within a single Class of Service (COS), and more than one rule matches the dialed number (containing a similar pattern). SIP Server will choose the outbound dialing rule with the most matched digits in it.

C. When integrating SIP Server with an approved third-party Softswitch, all SIP endpoints must be registered with the particular Softswitch and not the SIP server.

D. It is possible to configure Auto Agent Logout after a specific period of Agent inactivity on SIP Server 8.

In a SIP Server Stand-alone mode, persistent registrar data can be configured to be held by which of the following?

A. SIP Server

B. Softswitch

C. SIP Proxy

D. Configuration Server

Which protocol is SIP Server using when in communication with Softswitch?

A. CTI protocol

B. T-Lib

C. SIP

D. Proprietary protocol

You want to install one SIP Server and 3 Media Servers. You want to communicate with them directly using NET ANN. You also want each Media Server to support MOH, treatment and MCU. What will be the minimum number of VoIP Service DNs you have to configure to support this request?

A. 1

B. 3

C. 6

D. 9