DC0-200 Online Practice Questions and Answers

What is the correct NIC teaming for the Intel Proprietary Method to accomplish fault tolerance?

A. ATF

B. AFT

C. ALB

D. SLB

Which two components can be installed in the 0U space found in Dell racks? (Choose two .)

A. Dell PDU

B. Dell UPS

C. Dell Dual-Power Grid Switch

D. Dell flat panel monitor

What is required to enable a management application such as Dell OpenManage IT Assistant to receive SNMP traps from Dell OpenManage Server Agent/Server Administrator?

A. You configure the SNMP service on the computer on which OpenManage IT Assistant is running (the management station) to the correct read community name so that it can read the traps correctly .

B. You configure the SNMP service trap destinations on the computer on which Dell OpenManage Server Administrator is running to send traps to the management station (where OpenManage IT Assistant is running).

C. You make sure OpenManage IT Assistant has discovered the managed node running Dell OpenManage Server Administrator.

D. Nothing needs to be done. OpenManage IT Assistant automatically registers to receive traps when it discovers the managed node on which Dell OpenManage Server Administrator is running.

If there is a loss of power redundancy on your PowerEdge server, in which three ways can Dell OpenManage IT Assistant report this? (Choose three.)

A. Dell IT Assistant sends an alert to Dell OpenManage Server Administrator.

B. The status panel for that system indicates which power supply failed.

C. An SNMP trap can be logged in the OpenManage IT Assistant.

D. Systems Status is marked as "Warning" in OpenManage IT Assistant.

On most PowerEdge servers, the ESM is often updated with newer firmware. Which two devices are also updated by the ESM flash? (Choose two.)

A. System Setup

B. SCSI backplane

C. SCSI controller

D. Power Supply Paralleling Board

What happens when you specify a Preferred Primary Adapter in Windows 2000 for an AFT NIC team?

A. You specify which adaptor will take the load until it is saturated, then the other members will start accepting packets until the Preferred Primary is just below the saturation point.

B. You specify which adaptor will take the entire load. The other NICs will be used only when the Preferred Primary fails.

C. You specify the desired card for all incoming traffic for the team. The other members will still transmit outgoing packets.

D. You specify the desired card for all outgoing traffic for the team. The other members will still accept incoming packets.

Which two are provided by riser boards? (Choose two.)

A. redundant power conditioning and distribution for power redundant systems

B. a place to connect up to 16 DIMMs in 4U and larger systems

C. processor mounting parallel to the system board in 2U, quad processor systems

D. PCI slots parallel to the system board in 1U and 2U systems

You are monitoring 100 servers in your environment using ITA. You want to determine which servers are equipped with a remote access controller and the Array Manager agent, as well as view the physical memory of each server on one screen. How should you view this information from ITA?

A. go to the ITA Logs tab, select the information you want to view, and click the Refresh button

B. go to the ITA Inventory view, select the information you want to view, and click the Get Inventory button

C. go to the ITA Search view, select all the information you want to view using one query, and click the Search button

D. go to the ITA Remote Address Book, select the information you want to view, and click the Get Addresses button

Which three requirements must you meet to install OMSA in a Red Hat Linux environment? (Choose three.)

A. You must do a custom installation to support Linux.

B. The running kernel must have loadable module support enabled.

C. You must purchase the Linux version of OMSA.

D. The "ucd-snmp" or "net-snmp" package that is provided with the operating system must be installed.

E. You must be logged in as root.

What is the benefit of ECC memory?

A. provides redundancy by maintaining parity info on the DRAM to detect and correct single bit errors

B. provides redundancy by allowing defective memory to be disabled

C. provides speed improvements by allowing addressing to be set for the next access to the same DIMM, while data are being read from the previous access

D. provides speed improvements by accessing memory in parallel

You have just installed W2K on your server and you cannot get the server to see your local network. What can you do to diagnose network connectivity? (Choose three.)

A. verify that the subnet address is the same as the rest of the working devices on your LAN

B. verify that if attached to a switch and using VLANs, your port is in the proper configuration

C. verify that the server is configured to use DNS

D. verify that the cable plugged into your server is not a cross-over cable

Which statement is true about using the Save feature of BASP?

A. It is only available in Windows 2000.

B. It is used to install and configure the Broadcom Ethernet Controller driver.

C. It saves a configuration as an executable file.

D. It lets you transfer teaming configurations to other servers.

What should you do before removing or reseating the RAID memory?

A. disconnect the RAID battery

B. remove the hard drives

C. disconnect the RAID cable

D. disconnect the RAID key

You are attempting to install OMSA on a system. The only option offered by the installation GUI is Management Station. What are the two most likely causes for this? (Choose two.)

A. You are attempting to install OMSA from the management station CD-ROM.

B. You are attempting to install OMSA on a non-supported Dell PowerEdge server.

C. You are attempting to install OMSA on a non-PowerEdge Dell system.

D. You are attempting to install OMSA from a network-shared CD-ROM drive.

In Array Manager, what is the definition of a virtual disk?

A. abstract entity made up of array disks and/or array segments

B. one physical hard drive inside a storage subsystem

C. physical fibre storage subsystem

D. physical SCSI storage subsystem