VMware 2V0-41.19 dumps - 100% Pass Guarantee!

Which three steps must be taken to assign a new IP address to a member of a NSX Management Cluster that was deployed manually? (Choose three.)

A. Delete NSX Manager VM

B. Change IP address of NSX Manager in vApp Properties

C. Execute detach node from the NSX Manager CLI

D. Deploy new NSX Manager VM

E. Delete NSX Management cluster member from NSX Simplified UI

An NSX administrator is creating a NAT rule on a Tier-0 Gateway configured in active-standby high availability mode.

Which two NAT rule types are supported for this configuration? (Choose two.)

A. Port NAT

B. Source NAT

C. Destination NAT

D. 1:1 NAT

E. Reflexive NAT

An NSX administrator is troubleshooting a connectivity issue with virtual machines running on an ESXi transport node.

Which feature in the NSX Manager Simplified UI shows the mapping between the virtual NIC and the host's physical adapter?

A. N-VDS Visualization

B. Activity Monitoring

C. IPFIX

D. Port Mirroring

While planning a NSX-T Data Center deployment with a network administrator, you are told the physical network uses Open Shortest Path First (OSPF) for the Interior Gateway Protocol (IGP). The OSPF design is flat with the data center containing one OSPF area, area 0. The network administrator would like to extend area 0 into NSX-T so that dynamic routing updates will be learned bidirectionally.

Which meets the requirement?

A. Utilize static routes between the NSX-T topology and the physical network.

B. Recommend creating a new area for NSX-T to protect NSX-T's control plane from Link State Advertisement (LSA) floods from OSPF area 0.

C. Utilize the Border Gateway Protocol (BGP) on NSX-T and configure the physical network for route redistribution.

D. Utilize multi-protocol Border Gateway Protocol (BGP) in the NSX-T topology and configure the physical network for route redistribution.

Which NSX CLI command will enable the SSH service on the NSX Edge node?

A. set service ssh enabled

B. start service ssh

C. start service ssh start-on-boot

D. set service ssh start-on-boot enabled