6103 Online Practice Questions and Answers

After configuring your VSP 9000 for web access, engineers on the team says that they cannot log into EDM using their credentials.

What are the default credentials for EDM?

A. username: admin password: password

B. username: rwa password: rwa

C. username: admin password:

D. username: avaya password: avaya

During a power-on or cold-start sequence, at which stage can the flags to change the operational environment of the switch be set?

A. the boot monitor prompt

B. the image search

C. the system test

D. the boot configuration prompt

Using Enterprise Device Manager, the technician opens the ERS 8000 switch and sees that there are five ports showing with an orange light.

What does the orange light indicate?

A. The Ports have no link.

B. The Ports are in standby mode.

C. The Ports are being tested.

D. The Ports are manually disabled.

Refer to the exhibit.

While troubleshooting your VSP 9000 system, you run the command flight-recorder all

1. The associated files ace created.

Based on the information in the exhibit, where are the associated files stored?

A. Internal flash

B. TFTP Server

C. External flash

D. USB Flash device

Which file on the internal flash of Avaya Virtual Services Platform 9000 is used to specify the primary and backup release names?

A. version.cfg

B. releases.cfg

C. boot.cfg

D. config.cfg

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Virtual Services Platform (VSP) 9000 core. The technician needs to configure VRF on the VSP 9000.

Which statement represents the proper order for configuring a new VRF?

A. Create a new VLAN, add an IP address, create a VRF, and move the VLAN to the new VRF.

B. Create a VRF, add an IP address, create a new VLAN, and move the VLAN to the new VRF.

C. Create a VRF, create a new VLAN, add an IP address, and move the VLAN to the new VRF.

D. Create a VRF, create a new VLAN, move the VLAN to the new VRF, and add an IP address.

When configuring an Ethernet Routing Switch (ERS) 8000 for Split Multi Link Trunking (SMLT), protection against an edge switch in the factory default condition must be taken into consideration.

Which parameter will help prevent loops on the SMLT ports?

A. Enable SLPP.

B. Discard Looped Frames.

C. Enable Spanning Tree.

D. Enable LACP.

Which statement describes a characteristic of Routed Split Multilink Trunking (RSMLT) configuration?

A. RSMLT is only configured on edge SMLT connections.

B. RSMLT uses priority values to distinguish between the primary and backup routers.

C. RSMLT routers are implemented with the VRF-Lite routers.

D. RSMLT is always used in conjunction with routing protocols and SMLT connections.