Fortinet FCNSP.V5 dumps - 100% Pass Guarantee!

Which of the following represents the correct order of criteria used for the selection of a Master unit within a FortiGate High Availability (HA) cluster when master override is disabled?

A. 1. port monitor, 2. unit priority, 3. up time, 4. serial number

B. 1. port monitor, 2. up time, 3. unit priority, 4. serial number

C. 1. unit priority, 2. up time, 3. port monitor, 4. serial number

D. 1. up time, 2. unit priority, 3. port monitor, 4. serial number

Which of the following statements are correct about the HA diag command diagnose sys ha reset-uptime? (Select all that apply.)

A. The device this command is executed on is likely to switch from master to slave status if master override is disabled.

B. The device this command is executed on is likely to switch from master to slave status if master override is enabled.

C. This command has no impact on the HA algorithm.

D. This command resets the uptime variable used in the HA algorithm so it may cause a new master to become elected.

Which of the following statements is correct regarding the antivirus scanning function on the FortiGate unit?

A. Antivirus scanning provides end-to-end virus protection for client workstations.

B. Antivirus scanning provides virus protection for the HTTP, Telnet, SMTP, and FTP protocols.

C. Antivirus scanning supports banned word checking.

D. Antivirus scanning supports grayware protection.

Which of the following statements is not correct regarding virtual domains (VDOMs)?

A. VDOMs divide a single FortiGate unit into two or more virtual units that function as multiple, independent units.

B. A management VDOM handles SNMP, logging, alert email, and FDN-based updates.

C. A backup management VDOM will synchronize the configuration from an active management VDOM.

D. VDOMs share firmware versions, as well as antivirus and IPS databases.

E. Only administrative users with a super_admin profile will be able to enter all VDOMs to make configuration changes.

You are the administrator in charge of a FortiGate unit which acts as a VPN gateway. You have chosen to use Interface Mode when configuring the VPN tunnel and you want users from either side to be able to initiate new sessions. There is only 1 subnet at either end and the FortiGate unit already has a default route.

Which of the following configuration steps are required to achieve these objectives? (Select all that apply.)

A. Create one firewall policy.

B. Create two firewall policies.

C. Add a route for the remote subnet.

D. Add a route for incoming traffic.

E. Create a phase 1 definition.

F. Create a phase 2 definition.