Dell DCPPE-200 dumps - 100% Pass Guarantee!

A VRTX server is being set up for a new customer and configured with four blades. After a shutdown from a power outage, blades do NOT power up automatically upon power restore. Blades can be powered up either manually or via CMC.

Which setting should be verified to make sure blades automatically power up upon power restore?

A. Verify Power Control Operationsin the CMC GUI under Chassis Power Control

B. Verify chassis status with commandracadm autopowerup –m

C. Verify Power Configuration in the Lifecycle Controller GUI iDRAC Settings

D. Verify AC Power Recovery settings in the BIOS for each blade

A customer has five VRTXs in a chassis group that they need to disband. The engineer disbands the chassis group from the group leader, but a networking interruption prevents two of the VRTXs from getting the signal to leave the group.

What should the engineer do to finish disbanding the chassis group?

A. Remove the remaining members from the group leader's Remove Members list

B. Recreate the group fromthe group leader and disband it again

C. Remove the group association from the group members individually

D. Reboot the CMCs of the remaining members

A new node is added to a VRTX to create a compute cluster. This node needs to access the same virtual disk as an existing node in the VRTX.

Which two settings need to be modified to allow the node access? (Choose two.)

A. Assign the virtual disk Full Access on the new node

B. Change the virtual adapter to Multiple Assignment

C. Modify controller settings to SharedMode

D. Map the same virtual adapter to both nodes

An engineer needs to limit the power consumption of a chassis without powering down any server nodes.

Which step should the engineer take to perform this task?

A. Use the CMC to configure the System Input Power Cap for the chassis

B. Use the iDRAC to configure the Power Cap Policy for each server node

C. Use the CMC to configure the Power Cap Policy for each server node

D. Use the iDRAC to configure the System Input Power Cap for the chassis

An engineer is performing system updates on a large number of systems using OpenManage Essentials. The engineer has been instructed NOT to update network adapter firmware at this time.

How can the engineer exclude a firmware update while still using the Dell Online Catalog source?

A. Delete the firmware update from the local catalog.

B. Disable the firmware update in the catalog view.

C. Filter updates by component to exclude the firmware update.

D. Create a catalog policy to exclude the firmware update.