HP ACMA_6.3 dumps - 100% Pass Guarantee!

Which of the following is true of an Aruba Mobility Controller acting as a layer 2 switch? (Select two):

A. The Mobility Controller is the client's default router.

B. The Mobility Controller acts as a bridge.

C. All stations must use the same VLAN

D. Uplink ports on the Mobility Controller can use 802.1q tagging

E. VLANs cannot have IP addresses

When a client is blacklisted, the controller will:

A. Send a message telling the client it has been blacklisted

B. De-authenticate the client from the network but allow it to keep transmitting data

C. Only block the client if it hasn't yet associated with an AP

D. Stop the client from associating with any SSID on the controller

E. Block the client from the SSID he was connected to

When configuring roles under `Access Control' in the Controller's Configuration page, what does the `show reference' action tell us?

A. Which firewall hits were detected that refer to the role

B. Which profiles refer to the role

C. What policies are inside the role

D. What users are currently assigned that role

E. What authentication methods use Roles with these policies

In Extensible Authentication Protocol (EAP) terminology the client station is called the:

A. Station

B. Authenticated Client

C. Supplicant

D. End node

E. Client Device

What does SET ORIENTATION option do in the Visual RF Plan edit tool?

A. Set the horizontal plane on each floor

B. Give the option to resize a floor

C. Sets the North/South orientation of the building

D. Sets the proper vertical floor plan alignment

E. Allows the planner to set the directional antenna orientation