Cisco 200-401 dumps - 100% Pass Guarantee!

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

A. designated ports

B. duplex operating mode

C. fast mode ports

D. root bridge

E. root ports

F. BDPU priority

An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?

A. Enable port security and use the keyword sticky.

B. Set the switchport mode to trunk and save the running configuration.

C. Use the switchport protected command to have the MAC addresses added to the configuration.

D. Use the no switchport port-security command to allow MAC addresses to be added to the configuration.

An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is turned on and the switch port link LED turns green. The link light indicates what two conditions? (Choose two.)

A. Layer 2 communication has been established between the PC and switch.

B. The PC has received a DHCP address.

C. Traffic is being sent from the switch to the PC.

D. If flashing, the green LED indicates port speed of 100 Mb/s.

E. The Layer 1 media is functioning between the PC and switch.

F. The switch port is functioning as a half-duplex connection.

Which protocol is a secure alternative to Telnet?

A. SSH

B. FTP

C. SMTP

D. SNMP

E. HTTP

Which two reasons make mesh bonding systems most effective? (Choose two.)

A. cover wide areas

B. provide additional strength to floor structures

C. provide low-impedance noise-equalizing paths

D. create equipotential grounding systems

E. most cost-effective approach