Juniper JN0-692 dumps - 100% Pass Guarantee!

You have committed a configuration on router R1 as shown in the exhibit. However, it resulted in a (*, G) join for only one group (228.1.1.1) on R1.

Which additional configuration would result in the creation of a (*, G) join for the other group (232.1.1.1)?

A. Add relevant configurations for an SSM map.

B. Enable PIM version 1 on interface xe-5/2/0.0.

C. Configure another RP for the other group

D. Enable PIM on all interfaces.

Click the Exhibit button.

R2 is announcing the 10.200/16 network to its IS-IS neighbors. No routing policies have been applied to R3. Referring to the exhibit, will R5 have 10.200/16 as an IS-IS route?

A. Yes; IS-IS level 2 externals are passed from level 2 to level 1 by default.

B. No; IS-IS level 2 externals are only passed to level 1 if wide-metrics-only is configured on all routers.

C. Yes; all level 2 routing information is shared throughout an IS-IS domain by default.

D. No; IS-IS does not announce routes from level 2 to level 1 unless a routing policy is applied.

Click the Exhibit button.

Customer A is complaining that routes advertised from the CE2 router are not being received on the CE1 router. The physical topology of the network is CE1-PE1-PE2-CE2. The CE1-PE1 subnet is 172.16.1.0/24. The CE2-PE2 subnet is 172.16.2.0/24. PE1's loopback is 192.168.3.1 and PE2's loopback is 192.168.4.1.Referring to the output in the exhibit, what is the problem?

A. No LSP exists between PE1 and PE2.

B. Route targets are not properly configured.

C. as-override is not configured in the VRFs.

D. family inet-vpn is not configured on the PEs.

Click the Exhibit button.

R3 is announcing a route to R4 using EBGP, as shown in the exhibit. All routers in AS 65221 should learn this route, but it should not be announced to any other AS. What can be done to enforce this behavior?

A. R3 should add the community no-export to the route prior to announcing it.

B. R3 should add the community no-advertise to the route prior to announcing it.

C. R4 should add the community no-announce after receiving the route.

D. R4 should add the community no-advertise after receiving the route.

Click the Exhibit button

The 10.200/16 network is announced as an IS-IS route by R2 to its IS-IS neighbors. R3 and R4 are configured with an IS-IS export policy, which announces this route to R5 and R6.

Which statement is true?

A. When viewed on R5 the 10.200/16 route will be marked down.

B. When viewed on R5 the 10.200/16 route will be marked up.

C. The 10.200/16 route will not be visible on R5.

D. The 10.200/16 route will be marked with the overload bit.