Alcatel-Lucent 4A0-110 dumps - 100% Pass Guarantee!

Two routers are physically connected to each other over Ethernet port 1/1/1. Review the configuration information below. What state should the OSPF neighbor be in?

A. INIT

B. EXCHANGE

C. EXSTART

D. FULL

E. No OSPF neighbor

Based on the show display below, what should be done to further trouble the LSP problem? Choose all valid actions.

A. Check all the interface filters to make sure no LDP protocol is blocked

B. Check all management filters to make sure no RSVP-TE protocol is blocked

C. Verify all explicit hops are reachable via IGP

D. Make sure MPLS is enabled on all appropriate interfaces

E. Make sure LDP is enabled on all appropriate interfaces

A spoke-sdp terminated IES configured on Node 3 is down due on SDP serviceMTUMismatch error. The same error is found on the corresponding SDP on Node 4. The VPLS is using the default service MTU. Which MTU value should be modified to bring the SDP up on both Nodes?

A. IP MTU of the IES Interface on Node3

B. Port MTU on Node 3 and Node 4

C. SDP Path MTU on Node 3 and Node 4

D. Service MTU on Node 4

E. Path MTU on Node 3 and Node 4

Which command can be used to view all interfaces configured under VPRN 300?

A. Show router interfaces

B. Show router interface vprn 300

C. Show router 300 interfaces

D. Show service vprn 300 interfaces

E. Show service id 300 interfaces

Based on the following MP-BGP update packet, what is the export route-target of peer 10.10.1.4 on Node 1?

A. 100:100

B. 100:100 and 200:200

C. 200:200

D. 100:101

E. 200:101