Avaya 3605 dumps - 100% Pass Guarantee!

In a multicast campus, when should an ERS 8600 PIM interface be configured to run in passive mode?

A. When the interface is used as an edge interface and is aggregating traffic.

B. When the interface is used as a core interface and needs to limit PIM messages to reduce the system load.

C. When there are no unicast routing paths.

D. When more than one unicast routing protocol is in use.

What is a characteristic of Routed Split Multi-Link Trunking (RSMLT) configuration?

A. RSMLT is only configured on edge SMLT connections.

B. RSMI T uses priority values to distinguish between the primary and backup routers.

C. RSMLT routers are implemented with Virtual Routing Forwarding (VRF)-Lite routers.

D. RSMLT is always used in conjunction with routing protocols and SMLT connections.

The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with subscribed failover preventing any interruption of traffic on the network? What are the two primary benefits of this design goal? (Choose two)

A. In the event of a failure, no less of connectivity or application availability will be experienced by the end user.

B. This architecture provides high performance Layer 3 switching, resiliency, security, and services.

C. This design goal provides numerous connectivity options including Asynchronous Transfer Mode (ATM), Packet over SONET (POS), and 10 Gigabit Ethernet.

D. The design goal provides the ability to provide hitless software upgrade for the core of the network.

While configuring packet capture Tool (PCAP), an Ethernet Routing Switch (ERS) 8600 switch has generated the following log:

pcapAllocateBuffer: malloc(96 Mbs) failed

Which event could have caused this log, and which course of action resolves the issue?

A. The memory allocation failed to wrap. Set Pcmcia Wrap to true

B. The packet capturing stopped. Enable the Buffer-wrap or reset the stats.

C. The length of the IP frame is too long to capture. Turn on fragmentation

D. There is not enough available memory for PCAP. Try with a lower value of buffer-size.

The edge has been configured; the core configuration can be verified. Which configuration is the last step in the verification process?

A. MLT configuration check

B. Ext CP limit configuration check

C. SLPP configuration check

D. VLACP configuration check